Neon Car Wasteland Monster – Unpainted Resin Model Kit – 1/8 & 1/6 Scale – by Bulkamancer Sculpts

For a typical standing character (165–180 cm tall), 1/8 is about 21–23 cm (8–9 in) and 1/6 is about 27–30 cm (11–12 in).

Your figure can be taller or shorter than that. Big wings, a weapon or a tall base add height. A character sitting on a motorcycle or lying down ends up far lower than a standing one, so even a 1/6 figure can be around 15 cm tall.

The size shown in the listing is the full height of the finished figure, from the bottom of the base to the very top. That's the number to go by.

Our advice: 1/8 for a collection, 1/6 for the one figure you want noticed first.

Want the full size chart? Read our size guide.

You get the bare resin print. No primer, no paint, so every color choice is yours. The kit ships in parts and needs gluing.

Most painters do a little extra sanding before priming. We do the heavy cleanup, so you start from a prepared surface.

We print every kit ourselves on an Anycubic Photon Mono M7 Max resin printer. The resin is our own blend. It holds fine detail and stays slightly flexible, which makes thin parts less brittle than in standard resin prints.

Most kits are hollowed where it makes sense. That keeps the weight down and takes stress off large parts. Resin is still resin: drops and hard squeezes can break it, so handle it gently while you build and paint.

Some kits come with clear or tinted resin parts, for example energy blades, crystals, water or magic effects. You can leave them clear or paint around them.

It depends on how the model is built. Want clear parts, or a certain resin color, on a kit that doesn't have them? Ask before you order and we'll tell you what's possible.

Every kit is cleaned, cured and sanded before it goes in the box. We remove the supports by hand, wash the parts in an ultrasonic cleaner, cure them fully under UV light, then sand and prepare the surface.

We also move supports to less visible spots wherever we can, so they don't hurt important details. Perfection doesn't exist, and a few small spots may still need your attention. We keep that work to a minimum.

Each kit is wrapped and packed with protective materials made for resin models, and fragile parts get extra protection. Large kits often travel in several parts, each packed separately.

Tracking is included whenever the shipping service provides it. If something arrives damaged, write to us right away with photos of the damage and the packaging, and we'll work out a fair solution with you. If a part breaks later, send photos and we'll look at the options.

Want to follow along? Ask, and we'll send photos while your kit is printed and prepared. We can do this for many projects, depending on the kit and our schedule.

Prefer to wait for the box? That's fine too. It arrives when it's done.